HP ProLiant DL385 G7 - Full-Length Expansion Board Removal

Removal and replacement procedures 47
7.
Remove the expansion board.
To replace the component, reverse the removal procedure.
Full-length expansion board
To remove the component:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 27).
3. Remove the access panel ("Access panel" on page 33).
4. Disconnect any external cables that are connected to the expansion board.
5. Remove the PCI riser cage ("PCI riser cage" on page 43).
6. Disconnect any internal cables that are connected to the expansion board.
7. Remove the expansion board.