HP ProLiant DL385 G7 - Power Supply Cage Assembly Removal

Removal and replacement procedures 69
8.
Remove the three T-10 Torx screws, and then detach the front bezel.
To replace the component, reverse the removal procedure.
Power supply cage assembly
To remove the component:
1. Power down the server (on page 26).
2. Access the product rear panel (on page 28).
3. Remove all power supplies ("Hot-plug power supply" on page 31).
4. Remove the server from the rack (on page 27).
5. Remove the access panel ("Access panel" on page 33).
6. Remove the PCI riser cage ("PCI riser cage" on page 43).
7. Remove the air baffle ("Air baffle" on page 53).
8. Remove the power supply backplane ("Power supply backplane" on page 37).
9. Loosen the system board thumbscrews, and then slide the system board assembly forward.