HP ProLiant DL580 Gen10 - Hot-Plug Drive LED Definitions; Nvme SSD LED Definitions

Hot-plug drive LED definitions
Item LED Status Definition
1 Locate Solid blue The drive is being identified by a host application.
Flashing blue The drive carrier firmware is being updated or requires
an update.
2 Activity ring Rotating green Drive activity.
O No drive activity.
3 Do not remove Solid white Do not remove the drive. Removing the drive causes
one or more of the logical drives to fail.
O Removing the drive does not cause a logical drive to
fail.
4 Drive status Solid green The drive is a member of one or more logical drives.
Flashing green
The drive is doing one of the following:
• Rebuilding
• Performing a RAID migration
• Performing a strip size migration
• Performing a capacity expansion
• Performing a logical drive extension
• Erasing
• Spare part activation
Flashing amber/
green
The drive is a member of one or more logical drives
and predicts the drive will fail.
Flashing amber The drive is not configured and predicts the drive will
fail.
Solid amber The drive has failed.
O The drive is not configured by a RAID controller or a
spare drive.
NVMe SSD LED definitions
The NVMe SSD is a PCIe bus device. A device attached to a PCIe bus cannot be removed without allowing the device and bus
to complete and cease the signal/traic flow.
Component identification
117