HP ProLiant DL580 Gen10 - Removing and Replacing a Systems Insight Display

Removing and replacing a Systems Insight Display
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (
Extending the server from the rack).
• Remove the server from the rack (Removing the server from the rack).
4. Remove the access panel (
Removing the access panel).
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
5.
Remove the fan cage (Removing and replacing the fan cage)
6.
Remove the primary PCIe riser cage (
Removing a primary PCIe riser cage).
7.
If installed, remove the butterfly riser cage (Removing a butterfly PCIe riser cage).
8.
Remove the air bale (Removing the air bale).
9.
Remove the processor mezzanine tray (
Removing and replacing the processor mezzanine tray).
10.
Disconnect the cables from the system board depending on server configuration.
11.
Remove the Systems Insight Display.
To replace the component, reverse the removal procedure.
Removal and replacement procedures
49