• Extend the server from the rack (Extending the server from the rack).
• Remove the server from the rack (Removing the server from the rack).
4. Remove the access panel (Removing the access panel).
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
5. Remove the primary PCIe riser cage (Removing a primary PCIe riser cage).
6. If installed, remove the butterfly riser cage (Removing a butterfly PCIe riser cage
7. Remove the fan cage (
Removing and replacing the fan cage).
8. Remove the air bale (Removing the air bale).
9. If installed, remove the processor mezzanine tray (
Removing and replacing the processor mezzanine tray).
10. Disconnect the HPE Smart Storage Battery cable from the system board.
11. Remove the HPE Smart Storage Battery.
To replace the component, reverse the removal procedure.
Removing and replacing the secondary riser cage blank
Procedure
1.
Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
Removal and replacement procedures
87
To Next Page
Loading...
