To replace the component, reverse the removal procedure.
HPE Smart Storage Battery
The HPE Smart Storage Battery supports the following devices:
• HPE Smart Array SR controllers
• HPE Smart Array MR controllers
A single 96W battery can support up to 24 devices.
After the battery is installed, it might take up to two hours to charge. Controller features requiring backup power are not re-
enabled until the battery is capable of supporting the backup power.
This server supports the 96W HPE Smart Storage Battery with the 145mm cable.
Removing and replacing an HPE Smart Storage Battery
NOTE: System ROM and firmware messages might display "energy pack" in place of "Smart Storage Battery." Energy pack
refers to both HPE Smart Storage batteries and HPE Smart Storage Hybrid capacitors.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
86
Removal and replacement procedures
To Next Page
Loading...
