HP Proliant DL580 - Removing a Media Drive Blank; Removing a Media Drive

Removal and replacement procedures 23
Removing a media drive blank
1. Power down the server ("Powering down the server" on page 18).
2. Use the T-15 Torx screwdriver to eject the drive blank, and pull the drive
blank out of the server.
NOTE: The T-15 Torx screwdriver is shipped with the server and
can be located on the rear panel ("Rear panel components" on page
98
).
To replace the component, reverse the removal procedure.
Removing a media drive
To remove the DVD drive, optional diskette drive, or optional CD-RW drive:
1. Power down the server ("Powering down the server" on page 18
).
2. Use the T-15 Torx screwdriver to eject the drive, and pull the drive out of the
server.