HP Proliant DL580 - Server Operations; Server Power Management; Rack Mounting Procedures

24 HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
NOTE: The T-15 Torx screwdriver is shipped with the server and
can be located on the rear panel ("Rear panel components" on page
98
).
To replace the component, reverse the removal procedure.
Removing the processor module
NOTE: Refer the section "Processor module LEDs (on page 97)"
for information on the current processor and PPM status.
1. Power down the server ("Powering down the server" on page 18).
2. Remove the shipping bracket, if applicable.
NOTE: The shipping bracket is located near the processor module
lever, and is marked with an orange tab for easy identification.