60 HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
NOTE: If you remove or replace the primary hot-plug power
supply, use the T-15 Torx screwdriver provided with the server to
remove the shipping screw. It is located just under the port-colored
plastic handle of the power supply unit.
3. Remove the hot-plug power supply from the server.
CAUTION: To prevent improper cooling and thermal damage, do
not operate the server unless all bays are populated with either a
component or a blank.
To replace the component, reverse the removal procedure.
Replacing hot-plug fans
The server supports redundant hot-plug fans ("Fan locations" on page 114) to
provide proper airflow to the server if a primary fan fails.
WARNING: To prevent personal injury from hazardous
energy:
To Next Page
Loading...
