HP Proliant DL580 - Removing the SCSI Backplane

Removal and replacement procedures 45
7. Remove the media board.
To replace the component, reverse the removal procedure.
Removing the SCSI backplane
1. Power down the server ("Powering down the server" on page 18).
2. Remove all media drives ("Removing a media drive" on page 23
) and media
drive blanks ("Removing a media drive blank" on page 23
).
3. Remove all hard drives ("Removing a hot-plug SCSI hard drive" on page 50
)
and hard drive blanks ("Removing a hard drive blank" on page 49
).
4. Extend the server from the rack, if applicable.
5. Remove the access panel ("Removing the access panel" on page 19
).
6. Disconnect all cables from the SCSI backplane.
7. Remove the media board ("Removing the media board" on page 44
).