Removal and replacement procedures 51
3. Remove the hard drive.
To replace the component, reverse the removal procedure.
Removing a hot-plug SAS hard drive
CAUTION: Always power down the server if the boot partition
resides on the drive you are replacing or if you are replacing the only
drive in the server.
CAUTION: To prevent improper cooling and thermal damage, do
not operate the server unless all bays are populated with either a
component or a blank.
1. Determine the status of the hard drive from the hot-plug hard drive LEDs
("SAS and SATA hard drive LED combinations" on page 113
).
2. Back up all server data on the hard drive to be removed.
To Next Page
Loading...
