58 HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
5. Lift the latch, and remove the board from the server.
CAUTION: To prevent improper cooling and thermal damage, do
not operate the server unless all expansion slots have either an
expansion slot cover or an expansion board installed.
To replace the component, reverse the removal procedure.
Removing a power supply blank
NOTE: If you remove or replace the primary hot-plug power
supply, use the T-15 Torx screwdriver provided with the server to
remove the shipping screw. It is located just under the port-colored
plastic handle of the power supply unit.
To Next Page
Loading...
