26 HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
5. Release the latch, and open the cover to expose the processors.
NOTE: To install a new processor module, remove all processors
and PPMs from the processor module. Reinstall the processors and
PPMs into the replacement processor module.
To replace the component, reverse the removal procedure.
Removing a processor
CAUTION: To prevent thermal instability and damage to the
server, do not separate the processor from the heatsink. The processor,
heatsink, and retaining clip make up a single assembly.
CAUTION: To prevent possible server malfunction and damage to
the equipment, do not mix processors of different types.
IMPORTANT: If upgrading processor speed or adding additional
processors, update the system ROM before installing the processor.
IMPORTANT: Processor socket 1 and PPM slot 1 must be
populated at all times or the server will not function properly.
IMPORTANT: Always install a PPM when you install a processor.
The system fails to boot if the PPM is missing.
1. Power down the server ("Powering down the server" on page 18).
To Next Page
Loading...
