HP Proliant DL580 - Removing the Media Board

44 HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
5. Remove the battery.
To replace the component, reverse the removal procedure.
Run RBSU to configure the server after replacing the battery. Refer to the HP
ROM-Based Setup Utility User Guide on the Documentation CD for more
detailed information.
Removing the media board
1. Power down the server ("Powering down the server" on page 18).
2. Extend the server from the rack, if applicable.
3. Remove the access panel ("Removing the access panel" on page 19
).
4. Remove all media drives ("Removing a media drive" on page 23
) and media
drive blanks ("Removing a media drive blank" on page 23
).
5. Disconnect all cabling from the media board.
6. Loosen the thumbscrew, and slide the media board toward the front of the
server to disconnect it from the SCSI backplane.