40 HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
IMPORTANT: HP recommends troubleshooting the system using
port 85 codes before replacing the system board. Refer to
"Troubleshooting the system using port 85 codes (on page 84
)" for a list
of codes and troubleshooting procedures.
1. Power down the server ("Powering down the server" on page 18).
2. Remove all media drives ("Removing a media drive" on page 23
) and media
drive blanks ("Removing a media drive blank" on page 23
).
3. Remove all hard drives ("Removing a hot-plug SCSI hard drive" on page 50
)
and hard drive blanks ("Removing a hard drive blank" on page 49
).
4. Remove all memory boards ("Removing a memory board" on page 75
,
"Removing a memory board (non-hot-plug)" on page 73
) and memory board
blanks.
5. Remove the processor module ("Removing the processor module" on page
24
).
6. Extend or remove the server from the rack ("Removing the server from the
rack" on page 19
).
7. Remove the access panel ("Removing the access panel" on page 19
).
8. Remove the media board ("Removing the media board" on page 44
).
9. Remove the SCSI backplane ("Removing the SCSI backplane" on page 45
).
10. Remove all system fans ("Replacing hot-plug fans" on page 60
).
11. Remove all expansion boards ("Removing a non-hot-plug expansion board"
on page 33
, "Removing a PCI-X Hot Plug expansion board" on page 57).
12. Remove the PCI-X Hot Plug basket ("Removing the PCI-X Hot Plug basket"
on page 32
), if installed.
13. Disconnect the cable from the PCI-X Hot Plug mezzanine board, if installed.
14. Remove the system cage ("Removing the system cage" on page 20
).
15. Unlock the latch and open the lever.
To Next Page
Loading...
