HP ProLiant ML30 Gen10 Plus - Removing and Replacing the Serial Port Cable

If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel.
6. Remove the access panel.
7. If installed, remove the air baffle .
8. Disconnect the front USB ports from the system board .
9. Remove the front USB cable screws (callout 1), and then remove the cable from the front panel (callouts 2 and 3).
To replace the component, reverse the removal procedure.
Removing and replacing the serial port cableRemoving and replacing the serial port cable
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a hex screwdriver available.
ProcedureProcedure
1. Power down the server.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 104