To replace the component, reverse the removal procedure.
Drive replacementDrive replacement
Removing and replacing a non-hot-plug LFF SATA drive
Removing and replacing a hot-plug LFF SAS or SATA drive
Removing and replacing a non-hot-plug LFF SATA driveRemoving and replacing a non-hot-plug LFF SATA drive
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Back up all server data on the drive.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
