HP ProLiant ML30 Gen10 Plus - Removing and Replacing the Serial Port Blank

ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the iLO dedicated network port blank:
a. Use a spudger to pry the blank from the chassis (callout 1).
b. Remove the blank (callout 2).
To replace the component, reverse the removal procedure.
Removing and replacing the serial port blankRemoving and replacing the serial port blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the serial port blank:
a. Use a plastic spudger to pry the blank from the chassis (callout 1).
b. Remove the blank (callout 2).
Retain the blank for future use.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 99