4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel.
6. Unplug the USB device from the USB port.
To replace the component, reverse the removal procedure.
Removing and replacing the iLO dedicated network port blankRemoving and replacing the iLO dedicated network port blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
To Next Page
Loading...
