HP ProLiant ML30 Gen10 Plus - Removing and Replacing the Non-Hot-Plug Power Supply

c. Press and hold the release lever, and then slide the power supply out of the bay.
To replace the component, reverse the removal procedure.
Removing and replacing the non-hot-plug power supplyRemoving and replacing the non-hot-plug power supply
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply and the power supply blank
to cool before touching them.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 51