Removing the processor
Installing the processor
Processor cautionsProcessor cautions
CAUTION: CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or
install the processor in this server.
CAUTION: CAUTION: If installing a processor with a faster speed, update the system ROM before installing the processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support Center websiteHewlett Packard Enterprise Support Center website .
CAUTION: CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket or processor,
do not touch the contacts.
Removing the processorRemoving the processor
PrerequisitesPrerequisites
Review the processor cautions .
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Alcohol wipe
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
