HP ProLiant ML30 Gen10 Plus - Page 144

6. If installed, remove the air baffle .
7. Remove the iLO dedicated network port blank:
a. Use a spudger to pry the blank from the chassis (callout 1).
b. Remove the blank (callout 2).
8. Remove the tape above the iLO dedicated network port opening.
9. Remove the SSD mounting screw and hex nut from the 22110 standoff on the system board.
Retain the SSD mounting screw and hex nut for M.2 SSD installation.
Installing the iLO-M.2-serial module 144