HP ProLiant ML30 Gen10 Plus User Manual

Table of contentsTable of contents
1 Component identification
1.1 Front panel components
1.2 Front panel LED and button
1.2.1 Front panel LED power fault codes
1.3 Rear panel components
1.4 Rear panel LEDs
1.5 System board components
1.5.1 System maintenance switch descriptions
1.5.2 DIMM slot location
1.5.3 DIMM label identification
1.6 Drive bay numbering
1.7 HPE Basic Drive LED definitions
1.8 PCIe4 slot description
1.9 PCIe expansion slot definitions
1.10 HPE NS204i-p NVMe OS Boot Device components
1.11 HPE NS204i-p NVMe OS Boot Device LED definitions
1.12 Fan numbering
1.13 Fan mode behavior
1.14 Media device screws
1.15 Trusted Platform Module 2.0
1.15.1 Trusted Platform Module 2.0 guidelines
1.15.2 BitLocker recovery key/password retention guidelines
2 Operations
2.1 Power up the server
2.2 Power down the server
2.3 Remove the server from the rack
2.4 Remove the front bezel
2.5 Remove the access panel
2.6 Remove the air baffle
2.7 Remove the PCI blank retainer
2.8 Remove a media drive
2.9 Install the PCI blank retainer
2.10 Install the air baffle
2.11 Install the access panel
2.12 Install the front bezel
2.13 Install the server into the rack
3 Setup
3.1 Initial system installation
3.1.1 HPE Installation Service
3.1.2 Setting up the server
3.1.3 Setting up the server in tower mode
3.2 Operational requirements
3.2.1 Space and airflow requirements

HP ProLiant ML30 Gen10 Plus Specifications

General

Processor Sockets	1
Memory	Up to 128 GB DDR4 ECC UDIMM
Memory Slots	4
Form Factor	Tower
Processor	Intel Xeon E-2300 series
Storage	Up to 4 LFF or 8 SFF drives
RAID Support	HPE Smart Array S100i, S100i SR Gen10 SW RAID
Network	1 x 1GbE
Power Supply	350W
Chipset	Intel C252
Storage Controller	HPE Smart Array S100i, S100i SR Gen10 SW RAID
Maximum Internal Storage	Up to 64 TB
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Weight	Approx. 10.5 kg