Remove the server from the rackRemove the server from the rack
PrerequisitesPrerequisites
Before you perform this procedure, review the:
Rack warnings and cautions
Server warnings and cautions
A fully populated chassis is heavy. Hewlett Packard Enterprise recommends removing the external chassis components before
removing the server from the rack.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
5. Slide the server tray out of the rack:
a. Loosen the server tray thumbscrews (callout 1).
b. Grasp the tray notch and slide the server out of the rack (callout 2).
6. Remove the server from the tray.
To Next Page
Loading...
