HP ProLiant ML30 Gen10 Plus - Page 165

b. Install the removed hex nut on the 2280 standoff on the module.
9. Install the SSD:
a. Insert the SSD into the M.2 slot at a 45° angle (callout 1).
b. Carefully press the SSD down to the horizontal position (callout 2).
c. Install the SSD mounting screw (callout 3).
10. Install the air baffle .
11. Install the access panel .
12. Do one of the following:
Orient the server back in tower mode.
Install the server into the rack .
13. Connect all peripheral cables to the server.
Installing an M.2 SSD on the iLO-M.2-serial module 165