7. If the server is using a hot-plug power supply, secure the power cord in the strain relief strap attached to the power supply handle:
a. Unwrap the strain relief strap from the power supply handle.
CAUTION: CAUTION: Avoid tight bend radii to prevent damaging the internal wires of a power cord or a server cable. Never
bend power cords and server cables tight enough to cause a crease in the sheathing.
b. Secure the power cord with the strain relief strap. Roll the extra length of the strap around the power supply handle.
8. Employ industry best practices in routing and managing the peripheral cables and power cords.
9. Verify that the peripheral cables and power cords are secured properly.
Two people is needed for this procedure:Two people is needed for this procedure: one to slide the server in and out of the rack, and the other to observe the peripheral
cables and power cords.
a. Fully extend the server tray out of the rack.
b. Make sure that there is enough slack in the cables and cords for a full extension of the rack rails
To Next Page
Loading...
