HP ProLiant ML370 G5 - Operations; Server Power Management

Operations 20
Operations
In this section
Power up the server................................................................................................................................ 20
Power down the server............................................................................................................................ 20
Access the HP Systems Insight Display ...................................................................................................... 21
Open or remove the tower bezel.............................................................................................................. 21
Extend the server from the rack ................................................................................................................ 22
Remove the rack bezel............................................................................................................................ 23
Install the rack bezel............................................................................................................................... 25
Remove the access panel ........................................................................................................................ 25
Install the access panel ........................................................................................................................... 26
Remove the processor air baffle ............................................................................................................... 26
Remove the center wall ........................................................................................................................... 27
Power up the server
To power up the server, press the Power On/Standby button.
Power down the server
WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1. Shut down the OS as directed by the OS documentation.
2. Press the Power On/Standby button to place the server in standby mode. When the server enters
standby power mode, the system power LED changes to amber.
3. Disconnect the power cords.
The system is now without power.