HP ProLiant ML370 G5 - Removing a Hot-Plug Hard Drive

Hardware options installation 50
3.
Install the hard drive.
4. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations ("SAS and
SATA hard drive LED combinations" on page 16).
Removing a hot-plug hard drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations ("SAS and
SATA hard drive LED combinations" on page 16).
2. Back up all server data on the hard drive.
3. Remove the hard drive.