Hardware options installation 53
11.
Connect the 10-pin power cable to the drive cage backplane.
12. For rack models, install the rack bezel.
13. Install the access panel.
14. Install hard drives ("Installing a hot-plug hard drive" on page 49) or hard drive blanks, as needed.
15. Do one of the following:
• Close or install the tower bezel, as needed.
• Slide the server back into the rack.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
Removable media device options
The server supports the installation of a CD-ROM drive, USB tape drive, or optional diskette drive in the
removable media bay.
Removing the removable media blanks
1. Power down the server (on page 20).
2. Unlock the tower bezel.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
NOTE: HP recommends that you move the CD-ROM drive out of the media cabling area for ease of
installation. It is not necessary to disconnect and remove the CD-ROM drive from the server entirely.
To Next Page
Loading...
