Operations 26
NOTE: If the locking latch is locked, use a Torx T-15 screwdriver to unlock the latch.
Install the access panel
1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past
the rear of the server approximately 0.8 cm (0.2 in).
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch. The access panel slides to a closed position.
Remove the processor air baffle
1. Power down the server (on page 20).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 22).
3. Remove the access panel (on page 25).
4. Remove the processor air baffle.
To Next Page
Loading...
