Hardware options installation 36
IMPORTANT: Processor socket 1 must always be populated. If processor socket 1 is empty, the server
does not power up.
To install a processor:
1. Power down the server (on page 20).
2. Do one of the following:
• Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 21).
• Extend the server from the rack (on page 22).
3. Remove the access panel (on page 25).
4. Remove the processor air baffle.
5. Open the heatsink retaining latches.
To Next Page
Loading...
