Hardware options installation 46
5.
Remove the memory board and place it on a flat surface.
6. Do one of the following:
• Remove a FBDIMM ("Removing FBDIMMs" on page 47).
• Install a FBDIMM ("Installing FBDIMMs" on page 48).
7. Align the memory board with the memory slot and the memory board guide clips.
8. Install the memory board.
9. Install the processor air baffle.
10. Install the access panel.
11. Do one of the following:
• Close or install the tower bezel, as needed.
• Slide the server back into the rack.
12. Power up the server.
13. Configure the memory.
To Next Page
Loading...
