EasyManuals Logo

HP R5500 User Manual

HP R5500
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Installation 15
5.
Tighten the hex nuts.
Preparing the rails for integrated shipping
If the unit is to be shipped in an HP 9000 or 10000 series rack:
1. Remove the hex nuts, flat washers, and lock washers from the mounting rail.
2. Install the rail reinforcement plates and tighten using the hex nuts with captive washers included in
the kit, instead of the nuts included with the rail.
3. Install the rear mounting brackets using hex nuts. Wait until the unit is installed and the brackets are
adjusted before tightening the nuts.
Installing the UPS
Before installing the UPS, review and observe all warnings in "Precautions (on page 11)."
WARNING: Uneven mechanical loading in the rack may cause a hazardous condition.

Table of Contents

Other manuals for HP R5500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP R5500 and is the answer not in the manual?

HP R5500 Specifications

General IconGeneral
BrandHP
ModelR5500
CategoryUPS
LanguageEnglish

Related product manuals