Removing the Display Head from the Stand
1. Prepare the computer for disassembly (Preparation for Disassembly on page 46).
2. Remove the rear I/O panel (
Rear I/O Panel on page 49).
3. Remove the mounting bracket cover (
Mounting Bracket Cover on page 53).
4. Remove the display head back panel (
Display Head Back Panel on page 54).
5. Remove the RP7 display head from the stand by removing the three screws that attach the
stand's mounting bracket to the display head (1) then slide the display up and off the mounting
bracket (2).
To remove the display head back panel, reverse the installation procedures.
90 Chapter 8 Removal and Replacement Procedures
To Next Page
Loading...
