HP RP7 Model 7800 - B Configuring the Software; Touch Screen Calibration

Speaker
1. Prepare the computer for disassembly (Preparation for Disassembly on page 46).
2. Remove the rear I/O panel (
Rear I/O Panel on page 49).
3. Remove the mounting bracket cover (
Mounting Bracket Cover on page 53).
4. Remove the display head back panel (
Display Head Back Panel on page 54).
5. Remove the display head from the stand (
Removing the Display Head from the Stand
on page 90).
6. Remove the rear metal plate (
Rear Metal Plate (EMI shield) on page 91).
7. Remove the two Phillips screws (1) that secure the speaker to the computer.
8. Remove the cable from the clip (2).
9. Disconnect the cable from the system board connector labeled SPKR (3).
Figure 8-13 Removing the speaker
10. Remove the speaker from the computer.
To install the speaker, reverse the removal procedures.
Speaker 107