RP7 Adjustable Stand
NOTE: This section provides instructions for installing the RP7 Adjustable Stand if the stand was
purchased separately.
1. Prepare the computer for disassembly (Preparation for Disassembly on page 46).
2. Remove the power supply cover (
Power Supply Cover on page 47).
3. Remove the decorative panel (
Decorative Panel (IMD) on page 48).
4. Remove the rear I/O panel (
Rear I/O Panel on page 49).
5. Attach the RP7 display head to the stand's mounting bracket by aligning the slots on the display
head with the hooks on the mounting bracket and sliding the display down (1). Install the three
screws included with the stand through the mounting bracket and into the display head to secure
it in place (2).
RP7 Adjustable Stand 55
To Next Page
Loading...
