Table 3-4 Computer Setup—Security (continued)
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to enable/disable:
● Lock Legacy Resources (appears if a setup password is set). Default is enabled.
● Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
the F10 Setup Options without entering setup password). Default is enabled.
●
Password prompt on F9, F11, & F12 (allows access to menus without entering setup
password). Default is enabled.
●
Network Server Mode (appears if a power-on password is set). Default is disabled.
See the Desktop Management Guide for more information.
Smart Cover (some
models)
Allows you to:
● Lock/unlock the Cover Lock.
● Set the Cover Removal Sensor to Disable/Notify User/Setup Password.
NOTE: Notify User alerts the user that the sensor has detected that the cover has been
removed.
Default is disabled.
Device Security Allows you to set Device Available/Device Hidden (default is Device Available) for:
● Embedded security device (some models)
●
System audio
●
Serial ports (some models)
● Parallel port (some models)
●
Network controllers (some models)
●
SATA0
● SATA1
●
SATA2 (some models)
●
SATA4 (some models)
USB Security Allows you to set Enabled/Disabled (default is Enabled) for:
● Front USB Ports
◦ Monitor/USB Hub Ports
● Rear USB Ports
◦
RJ45/USB Port 1
◦
RJ45/USB Port 2
◦
4 Stack/USB Port 1
◦
4 Stack/USB Port 2
14 Chapter 3 Computer Setup (F10) Utility
To Next Page
Loading...
