20 Using the CLI
Example show disks command and response for an MSA1500
Example show unit #
command and response
CLI> show disks
Disk List: (box,bay) (B:T:L:) Size Speed Units
Enclosure 1: SATA SATA PROLIANT 8LCE
Disk101 (1,01) (0:03:01) 250.0GB 160 MB/s none
Disk102 (1,02) (0:03:02) 250.0GB 160 MB/s none
Disk103 (1,03) (0:03:03) 250.0GB 160 MB/s none
Disk104 (1,04) (0:03:04) 250.0GB 160 MB/s none
Disk105 (1,05) (0:03:05) 250.0GB 160 MB/s none
Disk106 (1,06) (0:03:06) 250.0GB 160 MB/s none
Disk107 (1,07) (0:03:07) 250.0GB 160 MB/s none
Enclosure 2: SCSI PROLIANT PROLIANT 4LEE
Disk201 (2,01) (1:00:00) 250.0GB 160 MB/s none
Disk202 (2,02) (1:01:00) 250.0GB 160 MB/s none
Disk203 (2,03) (1:02:00) 250.0GB 160 MB/s none
Disk204 (2,04) (1:03:00) 250.0GB 160 MB/s none
Disk205 (2,05) (1:04:00) 250.0GB 160 MB/s none
Disk206 (2,06) (1:05:00) 250.0GB 160 MB/s none
CLI> show unit 1
Unit 1:
In PDLA mode, Unit 1 is LUN 2; In VSA mode, Unit 1 is LUN 1
Unit Identifier:
Device Indentifier: 600805F3-00006B20-AE277D4B-B0D100F7
Preferred Path: Controller 1 (this controller)
Cache Status: Enabled
Max Boot Partition: Disabled
Volume Status: VOLUME OK
Parity Init Status: 3% complete
5 Data Disk(s) used by lun 1:
Disk107: Box 1, Bay 07, (B: T: L: 2;04:07)
Disk108: Box 1, Bay 08, (B: T: L: 2;04:08)
Disk207: Box 2, Bay 07, (B: T: L: 2;04:07)
Disk208: Box 2, Bay 08, (B: T: L: 2;04:08)
Spare Disk(s) used by lun 1:
No spare drive is designated
Logical Volume Raid Level: DISTRIBUTED PARITY FAULT TOLERANCE
(RAID5)
stripe_size=16KB
Logical Volume Capacity: 173,658MB
To Next Page
Loading...
