HP StorageWorks MSA1000

24 Using the CLI
Example show connections command and response
NOTE: Use the show connections command to verify that all connections to the MSA are recognized
and defined, including the profile type.
CLI> show connections
Connection Name: <unknown>
Host WWNN = 11111111-11111111
Host WWPN = 22222222-22222222
Profile Name = Windows
Unit Offset = 0
Controller 1 Port 1 Status = Online
Controller 2 Port 1 Status = Offline
Connection Name: <unknown>
Host WWNN = 33333333-33333333
Host WWPN = 44444444-44444444
Profile Name = Windows
Unit Offset = 0
Controller 1 Port 1 Status = Online
Controller 2 Port 1 Status = Offline
Example show preferred_path command and response
CLI> show preferred_path
Controller 1 (this_controller) is the current optimal path for these units;
0,1,4,5
Controller 2 (other_controller) is the current optimal path for these units;
2,3,6,7
Implicit (automatic load-based) LUN ownership changes are currently
DISABLED.
Controller 1 (this_controller) is the explicit power-up path for these
units; 0,1,4,5
Controller 2 (other_controller) is the explicit power-up path for these
units; 2,3,6,7