6 Setting time zone and configuring NTP server
Using the StoreOnce GUI to set the time zone
There is no default time zone set for your StoreOnce appliance.
1. In the Navigator, select Time and Date.
2. In Time zone setting, select your desired region from the Select Region drop down. The
list will contain a list of continents to choose from. Select the continent/region in which the
StoreOnce appliance is located.
3. In Select Country, select the country where the StoreOnce appliance is located.
4. In Select Time Zone, select the appropriate time zone within the country you have chosen.
5. In the header for the Time zone setting section of the GUI, click Apply.
6. An Apply Time Zone settings dialog will appear. Select Yes to apply your changes. Select
No to delete your settings.
A Time Zone setting success dialog box will appear. Click OK.
NOTE: The Date Settings portion of the Time and Date page allows you to manually set the
date and time of the appliance.
Using the StoreOnce GUI to configure NTP server
The NTP server configuration provides the option of setting the time and date using one or more
NTP servers. When using the NTP server to configure time and date, manual entry of time and
date will be disabled. You can add up to two NTP server configurations.
1. In the Navigator, select Time and Date.
2. In NTP Server Configuration, click the checkbox for NTP Selection Enabled.
3. In the NTP Server Configuration title bar, select Add.
4. In the Add NTP server dialog, enter the following:
• Select the NTP server type: IPv4, IPv6, or Fully Qualified Domain Name
• Add the chosen NTP server address into the Address field.
5. Click Add. The address will be added to the NTP server configuration and NTP will be
enabled.
Please note: There is no check that the NTP server is reachable after it is added to the
configuration.
Using the StoreOnce GUI to set the time zone 27
To Next Page
Loading...
Need help?
General