good practice to put the configuration name into the description field because the description
is copied to the current configuration, when the configuration is activated.
3. Click on the Create button. At this point a new configuration will be opened for you to edit.
NOTE: If there is an existing configuration that you wish to use as a template, select it
from the Copy Existing drop-down list.
4. As appropriate, select IPv4 or IPv6 for any DNS servers and enter the required addresses
in the appropriate format. Click Save.
Table 11 Network Configuration IP protocol and DNS fields
DescriptionField name
This reflects the name of the configuration selected in the
list.
Name of the configuration
This checkbox is always greyed out for the Current and
Factory Default configurations because they cannot be
Protected
edited. Custom configurations can be edited and the
checkbox is active to indicate their protection status.
DNS server details: These settings apply across all other settings.
To add a custom network configuration 45
To Next Page
Loading...
Need help?
General