3. Repeat until all the Subnets for the selected Port Set have been defined.
• Each physical Port Set may be configured with one Subnet that uses the IPv4 protocol
and one Subnet that uses the IPv6 protocol.
• If the Port Set is VLAN enabled, it is possible to add a total of 128 VLAN Subnets. These
total values apply across the whole network configuration, not per Port Set.
• If DHCP is used, one IPv4 and one IPv6 subnet will be consumed.
4. Click Save to save all configuration details.
Step 4 and 5: Validation and Activation
1. Click Validate to validate the network configuration. If there are any errors, the error message
will guide you to the parts of the configuration that need correcting. Make the necessary
changes, save them and click Validate again.
2. If validation is successful, you have two choices. The StoreOnce System Management GUI
will prompt you to activate the new configuration immediately. Or you can save it and activate
it separately from the Network Configuration — Custom page.
NOTE: It is not possible to activate a new configuration if storage addition is in progress.
To add a custom network configuration 49
To Next Page
Loading...
Need help?
General