NOTE: Note that once the Admin account password has been changed, its password cannot
be changed back to admin as this password is not sufficiently complex. The only way to revert
that password back to admin is via the HPresetpassword account which is only available on
the local console of the device.
• As you create new users, use the StoreOnce CLI system save config command to save
details of the new user accounts. This command does not save the password details, so
passwords for additional users should also be saved offline and kept in sync with the details
held on the HP StoreOnce Backup system.
User account and password requirements
• Local accounts can be between 1 & 16 characters in length and contain only alpha/numeric
and the following symbols - _
• External names may be up to 256 characters in length and contain alpha/numerics and the
following symbols: ~`!#$%()_-{}'.@\
• New passwords must be between 1 and to 24 characters and may contain only alpha\numerics
and the following symbols !@#$%^&* . The new password may not be the same as the current
password. The new password is not supplied for external users or groups.
Password best practices 35
To Next Page
Loading...
Need help?
General