Network configuration using net set wizard
NOTE: See Example network environment for a diagram illustrating the network configuration
that we are creating in this example.
The net set wizard guides you through the network configuration on the StoreOnce Backup
system and configures all network settings for all subnets.
Before running the wizard collect and verify the required information, see Before running net set
wizard (page 45).
To make additions or modifications to an existing network configuration, do not use net set
wizard because this will overwrite the current configuration. Instead, use the net modify or
net add CLI commands, as described in Modifying a network configuration (page 56) and the
HP StoreOnce Backup system CLI Reference guide.
NOTE: If you wish to configure encryption on a subnet, you can only do this using the StoreOnce
CLI commands. It is not configurable using the wizard. See To add Data in Flight
Encryption (page 59).
In the following example we shall use the net set wizard to support the following network
configuration:
• Two DNS servers
• One portset that uses the eth0 port only and will be used for a DHCP subnet.
• A second portset that is used for the Backup Data subnets and uses the bonded pair of 10GbE
ports, eth4 and eth5. This portset is VLAN-enabled. We shall set up one VLAN subnet initially
using the wizard, and then illustrate how to modify the configuration to add a second VLAN
subnet.
• A third portset that is used for StoreOnce Catalyst Copy and Replication subnet across the
WAN and uses the bonded pair of 1GbE ports, eth2 and eth3. We wish to use Mode 6
bonding on this portset, so it cannot be VLAN enabled. This subnet will also be configured
with the default gateway.
The configuration needs to support the following portsets and subnets.
48 Network configuration, how to use StoreOnce CLI commands
To Next Page
Loading...
Need help?
General