HP t5745 - Thin Client

4. Click on a remote server, and then click Next.
5. Select FTP or HTTP protocol. Type the remote server information in the fields.
NOTE: Username and Password are not required if you are using HTTP protocol.
6. Click Finish.
The HP ThinPro configuration restoration is complete.
Capture an HP ThinPro Configuration to a USB Drive
1. Attach a USB key to the thin client.
2. Click Control Panel > Management > Thinstate.
3. Select the HP ThinPro configuration, and then click Next.
4. Select save the configuration, and then click Next.
5. Click on a USB key, and then click Next.
124 Chapter 2 Installation ENWW