FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-7
Recovery. Informational message only; no corrective action is needed.
Cause. An attempt to open a labeled-tape file failed with file-system error 196 (tape
label record missing or incorrect).
Effect. The command fails.
Recovery. Verify that the specified DEFINE attributes match the label for the tape file.
Correct, if necessary, and retry the command. If the command fails again, for file-
system error 196 corrective action, see the Guardian Procedure Errors and Messages
Manual.
Cause. An internal error occurred while the system was processing DEFINEs.
Effect. The command fails.
Recovery. Note the error indicated by nnn and contact your service provider.
Cause. A RESTART operation was attempted, but the destination file was not corrupt,
which implies that the previous attempt to use DUP was successful.
Effect. The RESTART operation terminates.
Recovery. If you need to run DUP, perform an ordinary DUP operation.
Cause. The DP2 lock tables changed during the current LISTLOCK operation.
Effect. All lock information already displayed for filename is invalid.
FUP automatically starts over, retrieving and displaying current lock information for the
file identified by filename in the error message.
Recovery. Informative message only; no corrective action is needed.
Cause. The DP2 lock tables changed more than three times while FUP was
attempting to retrieve and display lock information for the filename identified in the
error message.
Effect. An error is generated, and the LISTLOCKS operation fails.
DEFINE DOES NOT MATCH TAPE LABEL OR TAPE LABEL IS BAD
DEFINE PROCESSING ERROR: nnn
DESTINATION FILE IS NOT FROM INTERRUPTED DUP
filename : DP2 LOCK TABLES !CHANGES: STARTING AGAIN
filename : DP2 LOCK TABLES CHANGING TOO FAST
To Next Page
Loading...
Need help?
General