FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-8
Recovery. Retry the LISTLOCKS operation.
Cause. The TAPEMODE parameter was used for a tape drive that does not support
the setting.
Effect. The COPY or BUILDKEYRECORDS command continues without trying to set
the tape mode.
Recovery. Informational message only; no corrective action is needed.
Cause. A DENSITYOUT parameter was specified for a tape drive that does not
support density selection, or the DENSITYOUT parameter was specified when the tape
was not at the beginning.
Effect. The COPY or BUILDKEYRECORDS command continues without trying to set
the density.
Recovery. Informational message only; no corrective action is needed if the tape drive
was at the correct density.
Cause. The same volume was specified for more than one partition of a partitioned
file.
Effect. The CREATE, ALTER, or DUP command fails.
Recovery. Each partition of a partitioned file must reside on a separate disk volume.
Cause. An error occurred while the system was reading an EDIT file (READEDIT); it
was probably a file-format error.
Effect. The command fails.
Recovery. For corrective action, see the Guardian Procedure Errors and Messages
Manual.
Cause. A file contained empty records.
DRIVE DOES NOT SUPPORT TAPEMODE SELECTION
DRIVE DOES NOT SUPPORT THIS DENSITY SELECTION OR CAN ONLY
CHANGE DENSITY AT BOT
DUPLICATE SECONDARY PARTITION VOLUME NAME
EDITREAD ERROR
source-file : EMPTY RECORD FOUND AND NOT TRANSFERRED
To Next Page
Loading...
