FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-20
Cause. A file-system error was encountered while attempting to open the indicated
file.
Effect. The command fails.
Recovery. For corrective action for the file-system error number indicated by nnn, see
the Guardian Procedure Errors and Messages Manual.
Cause. An SQL object was specified in a command that cannot operate on these
objects.
Effect. The command fails.
Recovery. If you intended to specify another type of file, retry the command after
correcting the file specification. To perform operations on SQL objects, use the SQL
Conversational Interface (SQLCI) for SQL/MP files and MXCI for SQL/MX files.
Cause. A CHECKSUM command specified an SQL view.
Effect. The operation is not performed on the view but will be performed on the next
object or file in the specified file set.
Recovery. If you intended to specify another type of file, retry the command after
correcting the file specification.
Cause. An SQL object was specified as a list file.
Effect. The command operation terminates.
Recovery. Retry the command, specifying a valid list file.
Cause. You specified a file on optical disk as the OUT file for the RUN FUP command
(for example, RUN FUP/OUT $OPT.X.Y/) or as the OUT file for the FUP commands
HELP, INFO, FILES, SUBVOLS, LISTOPENS, or SHOW (for example, HELP / OUT
$OPT.X.Y/ ALL).
Effect. The command fails.
Recovery. Retry the command with an OUT file residing on magnetic disk.
filename : OPEN ERR : nnn
OPERATION NOT ALLOWED ON SQL OBJECT
OPERATION NOT ALLOWED ON VIEW
OUT FILE CAN'T BE AN SQL OBJECT
filename: OUT FILE CAN'T BE ON OPTICAL DISK.
To Next Page
Loading...
Need help?
General