FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-19
Recovery. Retry the command after deleting the character that follows the
continuation character.
Cause. An operation was attempted in batch mode that can be performed only from a
terminal.
Effect. None.
Recovery. Perform the operation in interactive mode from a terminal.
Cause. A secondary partition was specified in a context where secondary partitions
are not allowed.
Effect. The command fails.
Recovery. Check that the file name is for the intended file, or use the PARTONLY
option if applicable to the command.
Cause. When an ALTER command was entered, only the PARTONLY option was
specified. No changes to the file were specified.
Effect. None.
Recovery. Retry the command, specifying the required changes.
Cause. An attempt was made to duplicate a file using the OLD option with either the
PART, ALTFILE, or EXT option. These options are mutually exclusive.
Effect. Only the OLD option is used, and the others are ignored. This is only a
warning.
Recovery. To change something using PART, ALTFILE, or EXT, do not use the OLD
option.
Cause. A RESTARTABLE DUP operation was attempted, but more than one source
file was specified.
Effect. The operation terminates.
Recovery. Specify only one source file when you perform the operation again.
NOT ALLOWED IN BATCH MODE
NOT PRIMARY PARTITION
NOTHING WAS SPECIFIED TO CHANGE
OLD OPTION USED: IGNORING ANY PART, ALTFILE OR EXTENT
OPTIONS
ONLY ONE SOURCE FILE ALLOWED WITH RESTARTABLE OPTION
To Next Page
Loading...
Need help?
General