FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-18
Cause. The specified text for the HISTORY, !, or ? command was not found in the
buffer.
Effect. None.
Recovery. Enter the correct text and try the command again.
Cause. The attempted command specified a nonexistent node.
Effect. None.
Recovery. Reenter the command with a valid node name.
Cause. The SAVEALL, SAVEID, or SOURCEDATE option of DUP was specified, and
an error occurred while saving one or more of the relevant attributes.
Effect. The DUP command finishes successfully, but not all the attributes are
transferred.
Recovery. Check which attributes did not transfer and transfer manually (if
necessary).
Cause. The attempted command was not allowed for partitioned files. For example, an
attempt was made to duplicate a partitioned file, specifying the OLD option without the
PARTONLY option.
Effect. The command fails.
Recovery. Check which commands are allowed with partitioned files.
Cause. The source file of a BUILDKEYRECORDS command or the destination file of
a LOAD command was an unstructured file.
Effect. The command fails.
Recovery. Specify a structured file in the command.
Cause. A character was entered on the same line after the continuation character (&).
Effect. The command fails.
NO SUCH SYSTEM
NOT ALL ATTRIBUTES WERE TRANSFERRED
NOT ALLOWED FOR PARTITIONED FILES
NOT ALLOWED FOR THIS FILE TYPE
NOT ALLOWED HERE
To Next Page
Loading...
Need help?
General